Watlow Electric Silver Series Guida di Installazione Scaricare il pdf (Pagina 11)

11 Watlow Silver Series OIT Installation Guide

0600-0069-0000 Rev B

clamps are in position.

2. Tighten the screw clamps in an even pattern until all are

uniformly snug.

Caution: Do not over-tighten the screws beyond snugness, or

you may damage the housing.

REINSTALLATION: If, at anytime, you are required to reinstall an OIT

into a panel, be aware that the gasket will take a ‘set’ to the panel and

may no longer provide an adequate NEMA 4 seal Therefore, for best

results, we recommend that you replace the gasket if reinstallation is

required.

Configuration Wiring

To configure the OIT using the EZware-5000 software, you will need the

correct configuration cable for your OIT. Please refer to the following

table for configuration cable options.

OIT Model

Ethernet Cable

USB Cable

P/N

0210-0382-0000

TS00-0043-0000 (HMI5043N)

TS00-0070-0000 (HMI5070TH),

TS00-0100-0000 (HMI5100T)

X X

Ethernet

If using a switch or router between the PC and the OIT, use a straight-

through or crossover cable as required by the switch or router.

USB

A USB driver (included with the EZware-5000 software) must be

installed when downloading from the PC to the OIT via a USB

connection. To install the USB driver, please refer to the help file ‘How

Do I’ section in EZware-5000 for detailed step-by-step instructions.

1 2 ... 6 7 8 9 10 11 12 13 14

Nessun commento

Watlow Electric Silver Series Guida di Installazione Pagina 11